2026-09-04

Chromium-based and Cadmium-based Pigments

Chromium-based and Cadmium-based Pigments Chromium-based Pigments Chromium-based pigments are inorganic pigments composed primarily of chromates.
Chromium-based and Cadmium-based Pigments

2026-08-07

Second-Generation Enamel "Anti-Fishscale Agent"

Enamel fish-scale cracking is a fatal defect in enamel products. Preventing fish-scale cracking and exploring solutions are common and thorny problems in the enamel industry.
Second-Generation Enamel "Anti-Fishscale Agent"

2026-07-31

Determination of Fineness, Specific Gravity and Adhesion of Enamel Slurry

1. Fineness Determination: (1). Traditional Method Take 50 ml (c.) or 100 c. of the enamel to be tested and pour it onto a 200-mesh sieve. Then wash it until no more clay or fine particles can pass through the sieve.
Determination of Fineness, Specific Gravity and Adhesion of Enamel Slurry

2026-07-24

Adjustment of Milling Additives Formulation

The grinding media formulation is also a crucial factor affecting the production operating conditions of enamel processing, especially its impact on enamel adhesion.
Adjustment of Milling Additives Formulation

2026-07-17

Antibacterial Porcelain Enamel (2) - Applicability of Antibacterial Agents to Enamel

2. Applicability of antibacterial agents to enamel Table 1 shows the composition of the antibacterial agent, and Table 2 shows the grinding ratio of the enamel slurry.
Antibacterial Porcelain Enamel (2) - Applicability of Antibacterial Agents to Enamel

2026-07-10

Antibacterial Porcelain Enamel

For enamel products related to daily life, the requirement for antibacterial properties is a current development trend both domestically and internationally.
Antibacterial Porcelain Enamel

2026-06-12

Two-Coat-One-Fire Enameling System (3) - Wet-to-Dry Process

2.3 Wet-to-Dry Process A ground coat slurry containing an adhesive is applied by spraying or dipping, then allowed to dry completely. Subsequently, a dry powder enamel is sprayed onto the dried ground coat using electrostatic spraying.
Two-Coat-One-Fire Enameling System (3) - Wet-to-Dry Process

2026-06-05

Two-Coat-One-Fire Enameling System (2) - Dry-to-Dry Process

2.2 Dry-to-Dry Process The ground coat powder containing an adhesive is applied to the surface of the substrate by electrostatic spraying, followed by spraying a powder cover coat enamel; no drying is required.
Two-Coat-One-Fire Enameling System (2) - Dry-to-Dry Process
< 12345 >