2026-01-08

The 26th International Enamel Congress (IEC 2026)

The 26th International Enamel Congress (IEC 2026) will be held in Paris, from June 1–4, 2026, at the UIC-P.
The 26th International Enamel Congress (IEC 2026)

2025-12-30

LIFAFRIT Union Activities: Building Bonds Beyond the Factory Floor

As 2025 drew to a close, the LIFAFRIT Union organized a vibrant and rejuvenating year-end event for the employees of the enamel frit factory,
LIFAFRIT Union Activities: Building Bonds Beyond the Factory Floor

2025-09-30

Lifafrit Imported High Quality Clay to Optimize Enamel Powder Production

Lifafrit always believe exceptional enamel frit begins with exceptional raw materials. We are proud to announce a significant enhancement to our production process.
Lifafrit Imported High Quality Clay to Optimize Enamel Powder Production

2026-06-12

Two-Coat-One-Fire Enameling System (3) - Wet-to-Dry Process

2.3 Wet-to-Dry Process A ground coat slurry containing an adhesive is applied by spraying or dipping, then allowed to dry completely. Subsequently, a dry powder enamel is sprayed onto the dried ground coat using electrostatic spraying.
Two-Coat-One-Fire Enameling System (3) - Wet-to-Dry Process

2026-06-05

Two-Coat-One-Fire Enameling System (2) - Dry-to-Dry Process

2.2 Dry-to-Dry Process The ground coat powder containing an adhesive is applied to the surface of the substrate by electrostatic spraying, followed by spraying a powder cover coat enamel; no drying is required.
Two-Coat-One-Fire Enameling System (2) - Dry-to-Dry Process

2026-05-29

Two-Coat-One-Fire Enameling System

The development of the pickling-free bonding ground coat and the two-coat-one-fire enamel frit in 1980 was the first breakthrough in enamel technology. This process not only broadened the range of steel plates used for enamel but also resulted in excellent adhesion after firing.
Two-Coat-One-Fire Enameling System

2026-05-22

Cast Iron Enamel Pre-treatment

Before enamel coating, castings should undergo surface grinding, firing, and sandblasting to clean them. During the casting process, castings inevitably have some casting defects such as mold seams and loose sand. These require manual cleaning and grinding to achieve a smooth and even surface.
Cast Iron Enamel Pre-treatment

2026-05-15

Enameling Systems

Abstract: The various enamelling systems which are currently available to us were reviewed. The advantages and disadvantages of each process method and their enviornmental impact were analyzed.
Enameling Systems
< 1234...9 >